Vision Miner Wiki

Quick Start Guide

Follow these steps in order to set up your Vision Miner 22 IDEX and get to your first successful print. Each step links to a full guide with detailed instructions.

Before you begin: Read the Safety article before performing any work on the printer.

From a freshly delivered crate to a finished part on the build plate — work through each step in order. Every step links to a dedicated article with the complete procedure, and step badges with a ▶ icon also link to the matching chapter in the videos below.

Unboxing VideoUnpack and inspect the printerComplete Setup VideoFull guided setup with chapter timestamps

Initial Setup

YouTube
Unboxing

Carefully unpack and prepare your printer for first use.

Installation RequirementsOptional

Ensure your workspace meets the necessary environmental and power criteria.

Network Connection

Connect your printer to the network. Choose the method that fits your setup:

WiFi

Connect wirelessly via your local network.

Ethernet

Wired network connection.

YouTube
Firmware UpdateOptional

Always good practice to update, but your machine is ready to print right out of the box.

Operating the Machine

Interface OverviewOptional

The interface is self-explanatory. Refer to this video if you need additional guidance.

YouTube
Auto CalibrationOptional

Your machine comes pre-calibrated from the factory. This step is optional.

Prepare to Print

YouTube
Filament Loading

Learn how to correctly load filament into both toolheads.

YouTube
Slicer Setup

Install and configure PrusaSlicer with Vision Miner profiles.

YouTube
NPA Application

Apply Nano Polymer Adhesive to the build plate before your first print.

YouTube
First Print

Prepare the build plate, slice a model, and start your first print.

On this page

Initial Setup
Operating the Machine
Prepare to Print

Your feedback makes it better for everyone.